Cisco T3 kit CAB-T3-KIT5= User Manual
Product codes
CAB-T3-KIT5=
Page 5 of 28
78-19803-02 Cisco TelePresence System T3 System Assembly Guide, December 2011
Bottom modules & monitors
Unpack the box marked “T3 Floor structure and columns”.
The box contains the parts shown below. Items are not
shown to scale.
The box contains the parts shown below. Items are not
shown to scale.
Right system
cover plate
cover plate
Center cover plate(I)
Center cover
plate (II)
Left system
cover plate
cover plate
Left c
over
pla
te
Righ
t cover
pla
te
Center
bottom frame
Right bottom frame
Left bottom frame
Nut plate (8×)
Module
angle plate
(2×)
angle plate
(2×)
Cleaning kit
pocket
Splitter bracket
Document
pocket
Cable
channel (2×)
channel (2×)
Splitter power
supply bracket
supply bracket
Codec bracket (3×)
In addition the box contains the two table columns (not
shown). These shall be installed later. Put them aside right
now.
shown). These shall be installed later. Put them aside right
now.
Do as follows:
1.
1.
Begin by placing the center bottom frame centered
on the floor, approximately 4.2 m (13’ 9”) from the rear
(white) wall. The distance between the white and
the blue wall is 140 mm (5½”). Observe the 130 cm
requirement (see the below right sidebar).
on the floor, approximately 4.2 m (13’ 9”) from the rear
(white) wall. The distance between the white and
the blue wall is 140 mm (5½”). Observe the 130 cm
requirement (see the below right sidebar).
Doo
r
4.06 m
13’3
13’3
1
⁄
2
”
2.
Unpack the bag containing screws, nuts and plates,
located in the Accessories box. Contents should be as
shown on the next page.
located in the Accessories box. Contents should be as
shown on the next page.
Note!
The system has been designed for rooms with
entrance door opening outwards. Should you for any
reason be unable to fulfill this requirement, make sure
you position the system so that it will not block the door
from opening completely.
reason be unable to fulfill this requirement, make sure
you position the system so that it will not block the door
from opening completely.
Note!
The distance between the table and the rear wall
of the room should not exceed 130 cm (4’ 3”) as this will
affect the perceived immersive room quality (the other
side should see nothing but blue walls, avoiding any
sidewalls coming into view):
affect the perceived immersive room quality (the other
side should see nothing but blue walls, avoiding any
sidewalls coming into view):
a)
Distance to rear wall is 130 cm (4’ 3”)
b)
Distance has been increased to 155 cm (5’)
c)
Distance has been increased to 180 cm (6’)