Manualsbrain.com
  1. Manuals
  2. Brands
  3. ZyXEL Communications
  4. NWA-1100
  5. User Manual

ZyXEL Communications NWA-1100 User Manual

Download
Page of 206
 Chapter 13 Log Screens
ZyXEL NWA-1100 User’s Guide
119
13.6.1  Example Log Messages
The following tables provide descriptions of some example log messages that the ZyXEL 
Device generates.
13.7  Log Commands
Go to the command interpreter interface (refer to 
 for the Command Interpreter 
appendix explains how to access and use the commands).
13.7.1  Configuring What You Want the ZyXEL Device to Log
Use the sys logs load command to load the log setting buffer that allows you to configure which logs 
the ZyXEL Device is to record.
Table 38   System Maintenance Logs
LOG MESSAGE
DESCRIPTION
WLAN: Radar interference 
2412 MHz.
Wireless driver receives radar pulse at center frequency 2412 
MHz.
WLAN: CW interference 
2412 MHz.
Wireless driver receives noise interference pulse at center 
frequency 2412 MHz.
WLAN service started.
Wireless port ath0 started.
WLAN service stopped.
Wireless port ath0 stopped.
AP MIC failed.
Wireless driver MIC checked failed.
AP MIC attacked.
Wireless driver received MIC attack packet.
Station authenticated.
AP received the request for authentication from station and 
authenticated the station successfully.
Station authentication 
failed.
AP received the request for authentication from station but the 
authentication failed.
Station deauthenticated.
AP receive the deauthenticated packet from the STA which 
connected with AP.
Station associated.
AP receive the association request packet from the STA which 
connected with AP.
Station disassociated.
AP receive the disassociation request packet from the STA, which 
connected with AP.
Station refused.
A STA wanted to connect to the AP but was refused.
Remote Bridge AP 
configured.
Remote AP MAC address was configured.
Remote Bridge AP 
deleted.
Remote AP MAC address was deleted.
CLI: Authorized user 
from IP.
A device succesfully logs into the AP via Telnet  (the device’s IP 
address shows in the log message.)
CLI: Unauthorized user 
from IP.
A device fails to log into the AP via Telnet  (the device’s IP address 
shows in the log message.)
WEB: Authorized user 
from IP.
A device successfully logs into the AP via WWW  (the device’s IP 
address shows in the log message.)
WEB: Unauthorized user 
from IP.
A device fails to log into the AP via WWW (the device’s IP address 
shows in the log message.)