Thecus All-Purpose Storage Server N1200BR Leaflet

 

 
 

72 

a)  Make sure that the unit is powered off. With the unit powered off, 

press and hold the reset button. With the reset button held down, 

power on the system by pressing the power button. You will hear 
the unit beep once when you turn it on, do not release the reset 

button until you hear the unit beep again.. (The Reset button is 
near the LAN connector) 

b)  This resets the N1200 to its default IP address and password 

settings. 

• 

Default IP: 192.168.1.100 

• 

Default admin password: admin 

 

2.  Attach the power cord and connect the LAN cable between the N1200 and 

a PC. Don’t use a hub. 

 

3.  Turn on the N1200 and check the front panel. The Power LED should 

glow blue after power button is pressed. Then, the Busy LED starts 
blinking orange for around 60 seconds. After that, the Busy LED turns off. 
If the Busy LED keeps blinking orange for more than 3 minutes, the 

firmware may be corrupted during improper firmware upgrade procedures. 
It means that the motherboard has malfunctioned and needs to be 

repaired. 

 

4.  Set the IP address of the PC as 192.168.1.111, and then access the 

Login page. Make sure the N1200 and the PC is directly connected 

through a LAN cable, and not through a hub or a router. 

 

5.  Check if the Web Administration Interface shows up and works fine. Then, 

check if the system status is normal and the HDD Power LED works fine. 
If the results are positive, it means that the N1200 is functioning normally. 

Otherwise, the N1200 may be damaged. 

 

6.  Suppose that the N1200 has been damaged. If the Power LED glows blue 

and both system and power fans work fine after power button pressed, the 

motherboard needs to be checked and repaired. Otherwise, the power 
supply unit has problems.