Thecus All-Purpose Storage Server N1200BR Leaflet

 

 
 

70 

Powered off the unit first. With the unit powered off, press and hold the reset 
button. With the reset button held down, power on the system by pressing the 

power button. You will hear the unit beep once when you turn it on, do not 
release the reset button until you hear the unit beep again. After that, the 
N1200's WAN IP address will be reset to 192.168.1.100 temporarily. Please note 

that all file services at this time will be stopped. 
 

1.  Point your browser to 192.168.1.100, you will see the following screen: 

  

 

2.  If you select “Run file system check” option, the file system check utility will be 

started, and last 20 lines of the result will be displayed in your browser.

 

3.  When the file system check is finished, the result will be displayed in your browser. 

If you forget your network IP address and have no physical access to the system, 
you can use the setup wizard to retrieve the IP of your N1200. 
 

1.  Start the Setup Wizard, and it will automatically detect all 

Thecus IP storage products on your network. 

 

2.  You should be able to find the IP address of the N1200 

which you have forgotten in the Device Discovery 
screen. 

If you cannot access the N1200 from the LAN, make sure that its network cable is 

correctly plugged in. Also, check to see if the N1200’s WAN and LAN settings are 
configured correctly.  

You may have problems mapping a network drive under the following conditions: