Sony CDX-DAB500U User Manual

Page of 168
26
Specifications
Tuner section
DAB/DAB+/DMB-R
Tuning range:
 174.928 – 239.200 MHz
Usable sensitivity:
 –97 dBm
Antenna (aerial) terminal:
External antenna (aerial) connector
FM
Tuning range: 
87.5 – 108.0 MHz
Antenna (aerial) terminal:
 
External antenna (aerial) connector
Intermediate frequency:
 25 kHz
Usable sensitivity:
 8 dBf
Selectivity:
 75 dB at 400 kHz
Signal-to-noise ratio:
 80 dB (stereo)
Separation:
 50 dB at 1 kHz
Frequency response:
 20 – 15,000 Hz
MW/LW
Tuning range:
 
MW: 531 – 1,602 kHz
LW: 153 – 279 kHz
Antenna (aerial) terminal:
 
External antenna (aerial) connector
Intermediate frequency:
 
9,124.5 kHz or 9,115.5 kHz/4.5 kHz
Sensitivity:
 MW: 26 μV, LW: 45 μV
CD Player section
Signal-to-noise ratio:
 120 dB
Frequency response:
 10 – 20,000 Hz
Wow and flutter:
 Below measurable limit
USB Player section
Interface:
 USB (Full-speed)
Maximum current:
 1 A
Power amplifier section
Output:
 Speaker outputs
Speaker impedance: 
4 – 8 ohms
Maximum power output:
 52 W × 4 (at 4 ohms)
General
Outputs:
 
Audio outputs terminal (front, rear/sub 
switchable)
Power antenna (aerial)/Power amplifier control 
terminal (REM OUT)
Inputs:
 
Remote controller input terminal
DAB antenna (aerial) input terminal
FM/MW/LW antenna (aerial) input terminal
AUX input jack (stereo mini jack)
USB port
Power requirements:
 12 V DC car battery 
(negative ground (earth))
Dimensions:
 Approx. 178 × 50 × 177 mm 
(7
1
/
8
 × 2 × 7 in) (w/h/d)
Mounting dimensions:
 Approx. 182 × 53 × 160 mm 
(7
1
/
4
 × 2
1
/
8
 × 6
5
/
16
 in) (w/h/d)
Mass:
 Approx. 1.2 kg (2 lb 11 oz)
Supplied accessories:
 
Remote commander: RM-X211
Parts for installation and connections (1 set)
Optional accessories/equipment:
 
USB connection cable for iPod: RC-100IP
Your dealer may not handle some of the above 
listed accessories. Please ask the dealer for 
detailed information.
Design and specifications are subject to change 
without notice.
Troubleshooting
The following checklist will help you remedy 
problems you may encounter with your unit.
Before going through the checklist below, 
check the connection and operating 
procedures.
For details on using the fuse and removing the 
unit from the dashboard, refer to the 
installation/connections manual supplied with 
this unit.
If the problem is not solved, visit the support 
site on the back cover.
General
No power is being supplied to the unit.
 Check the connection or fuse.
 If the unit is turned off and the display 
disappears, it cannot be operated with the 
remote commander. 
– Turn  on  the  unit.
The power antenna (aerial) does not extend.
 The power antenna (aerial) does not have a 
relay box.
No sound.
 The ATT function is activated.
 The position of the fader control “FADER” is 
not set for a 2-speaker system.