Sony CDX-DAB500U User Manual
27
you are not using the built-in amplifier.
The contents of the memory have been
erased.
The power supply lead or battery has been
erased.
The power supply lead or battery has been
disconnected or not connected properly.
The unit is reset.
– Store again into the memory.
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the
ignition is switched.
The leads are not matched correctly with the
The fuse has blown.
Makes noise when the position of the
ignition is switched.
The leads are not matched correctly with the
car’s accessory power connector.
During playback or reception,
demonstration mode starts.
If no operation is performed for 5 minutes
demonstration mode starts.
If no operation is performed for 5 minutes
The display disappears from/does not
appear in the display window.
The dimmer is set to “DIM-ON” (page 22).
The display disappears if you press and hold
appear in the display window.
The dimmer is set to “DIM-ON” (page 22).
The display disappears if you press and hold
.
– Press
– Press
on the unit until the
display appears.
The connectors are dirty (page 25).
The Auto Off function does not operate.
The unit is turned on. The Auto Off function
The unit is turned on. The Auto Off function
activates after turning off the unit.
– Turn off the unit.
– Turn off the unit.
The operation buttons do not function.
The disc will not eject.
Press and
The disc will not eject.
Press and
(BACK)/
for
more than 2 seconds.
The contents stored on the memory are erased.
For your safety, do not perform the reset
operation while you are driving
The contents stored on the memory are erased.
For your safety, do not perform the reset
operation while you are driving
Radio reception
The stations cannot be received.
The sound is hampered by noises.
The connection is not correct.
The sound is hampered by noises.
The connection is not correct.
– Check the connection of the car antenna
(aerial).
– If the auto antenna (aerial) will not go up,
check the connection of the power antenna
(aerial) control lead.
(aerial) control lead.
See “NO SERVICE” (page 29) for details when
the DAB signal cannot be received.
Preset tuning is not possible.
Store the correct frequency in the memory.
The broadcast signal is too weak.
Store the correct frequency in the memory.
The broadcast signal is too weak.
Automatic tuning is not possible.
The broadcast signal is too weak.
The broadcast signal is too weak.
– Perform manual tuning.
RDS
The SEEK starts after a few seconds of
listening.
The station is non-TP or has weak signal.
listening.
The station is non-TP or has weak signal.
– Deactivate TA (page 10).
announcements despite being TP.
– Tune in another station.
– Tune in another station.
PTY displays “- - - - - - - -.”
The current station is not an RDS station.
RDS data has not been received.
The station does not specify the program type.
The current station is not an RDS station.
RDS data has not been received.
The station does not specify the program type.
Program service name flashes.
There is no alternative frequency for the
There is no alternative frequency for the
current station.
– Press
– Press
+/– while the program service
name is flashing. “PI SEEK” appears and the
unit starts searching for another frequency
with the same PI (Program Identification)
data.
unit starts searching for another frequency
with the same PI (Program Identification)
data.