Eurochron Efws 302 X45155 Data Sheet

—

Open the battery compartment on the weather station's rear by pushing the
battery compartment lid downwards.

—

Then insert two AA/mignon batteries into the battery compartment (16) of the
weather station with correct polarity (observe plus/+ and minus/-).

—

Close the battery compartment again.

—

After inserting the batteries, the weather station will briefly display all display
segments.

—

Briefly after that, the indoor temperature is displayed; then the weather station
starts searching for the outdoor sensors. The channel number of the outdoor
sensor flashes in the display. The sensor search takes about  5 minutes. Do not
move the weather station during this time and do not press any buttons.
Then the weather station attempts initial reception for the DCF signal; the icon
"

" flashes in the lower right of the display (if a DCF signal is recognised).

The DCF reception attempt may take 5 minutes or more. Do not move the weather
station during this time and do not press any buttons.
Observe chapter 10 on DCF reception.

—

The weather station can be suspended by a nail, hook or screw using the wall
mounting hole (13).
The included standing base (17) can be used to set up the weather station on a
level, stable surface. Place the weather station in the groove deposit of the
standing base. A magnet integrated in the standing base then fastens the
weather station.
This way, the weather station can be easily removed from the standing base.

(

Also observe the chapter "14. Transmission Range" for setting up the outdoor
sensor and weather station.