Futaba 10J F4109 Data Sheet

① Call the menu screen from the 

home screen by pressing the + 

key  for 1 second.

＋

② Select 

    from the menu with the 

Jog key.

③ Open the setting screen by 

pressing the Jog key.

（1 second）

Ailevator mixes both Ailerons and Elevators together. Or the 

function can be used separate from your ailerons when you have two 

Elevator servos.  Since there are aircraft like jet fighters that use the 

elevators as ailerons, using this function can give you a sense of reality. 

Aileron operation can also be used with 2 elevator servo specifications. 

The servos connect to the receiver CH2 and CH8 output.

●Elevator and aileron travel can be adjusted individually.

●Confirm the direction of operation, because it is different depending 

on the linkage.

CH2 servo

CH8 servo

Roll

AIL3

AIL4

Pitch

ELE1

ELE2

● Select the setting item with 

the Jog key.

● When  INH  is  selected,  the 

function cannot be used. To use 

the function, select ACT.

（Rate）

① Select the "MIX" item and then 

select the "ACT" by pressing 

the + key or – key.

＋

－

or

● W h e n  y o u  d o  n o t  u s e  a 

function, set to the "INH" side. 

＋

－

or

② Select the "RATE" item and then adjust 

the mixing rate by pressing the + key or 

– key.

Range：-100 ～ +100%

Default：-50%（AIL3, AIL4）,

-100%（ELE2）, +100%（ELE1）

● When you want to return the set value to the initial value, press 

the + key and – key simultaneously.However, polarity does not 

return.

NOTE：We recommend that setting be performed while moving the stick and checking the amount of movement. If 

the amount of movement is too large, elevator and aileron operation will be compounded and the servo travel range 

will be exceeded and a dead band in which the servo will not operate may be created.

● When used as 2 elevator servos specifications without aileron operation, set the AIL3 and AIL4 travel to 0%.

  CH 2

（CH 8）

 CH 6

(CH7)

CH 1

  CH 8

（CH 2）

NOTE：Ailevator cannot be used simultaneously with  V-tail or Elevon functions.  When “Other WING mix “ON” “is 

displayed on the screen, set the ailvator function to ACT after setting the active function to INH.