Futaba 10J F4109 Data Sheet

① Call the menu screen from the 

home screen by pressing the + 

key  for 1 second.

＋

② Select 

    from the menu with the 

Jog key.

③ Open the setting screen by 

pressing the Jog key.

（1 second）

This mixing is used with delta wing, tailess, and disk shaped 

airplanes that combine the aileron and elevator functions. 

Connect the CH1 servo to the left aileron and the CH2 servo to the 

right aileron.

●The aileron and elevator travel can be adjusted individually.

NOTE：Elevon cannot be used simultaneously with  V-tail or Ailevator 

functions. You may use Flaperon or Differential when this function is active. 

If another function is already active, “Other WING mix “ON” is displayed on 

the screen. After setting the active function to “INH” , set the V-tail function 

to “ACT” .

CH1 servo

CH2 servo

Roll

AIL1

AIL2

Pitch

ELE2

ELE1

Aileron1（CH1）rate

Aileron2（CH2）rate

Elevator2（CH1）rate

Elevator1（CH2）rate

● When  INH  is  selected,  the 

function cannot be used. To use 

the function, select ACT.

（Aileron rate）

L：Aileron stick Left side rate 

R：Aileron stick Right side rate 

（Elevator rate）

● Select the setting item with 

the Jog key.

① Select the "MIX" item and then 

select the "ACT" by pressing 

the + key or – key.

＋

－

or

●When you do not use a function, 

set to the "INH" side. 

＋

－

or

② Select the "RATE" item and then adjust 

the mixing rate by pressing the + key or 

– key.

Range：-120 ～ +120%

Default：+100%

（only ELE1 :  -100%）

● When you want to return the set value to the initial value, press 

the + key and – key simultaneously.However, polarity does not 

return.

NOTE：We recommend that setting be performed while moving the stick and checking the amount of movement. If 

the amount of movement is too large, elevator and aileron operation will be compounded and the servo travel range 

will be exceeded and a dead band in which the servo will not operate may be created.

CH1

CH1

CH2

CH2

Pitch

Roll