Futaba 10J F4109 Data Sheet

27

Each transmitter has an individually assigned, unique ID code. In order to start operation, the 

receiver must be linked with the ID code of the transmitter with which it is being paired. Once the 

link is made, the ID code is stored in the receiver and no further linking is necessary unless the 

receiver is to be used with another transmitter. When you purchase additional R3008SB receivers, 

this procedure is necessary; otherwise the receiver will not work. 

1. Place the transmitter and the receiver 

close to each other within 20 inches(half 

meter).

 
2. Turn on the transmitter. 
3. Select [MDL-SEL] and access the setup 

screen shown below by press the jog key .

4. Use the jog key to select (NO LINK) or the 

ID number next to LINK in the [MDL-SEL] 

menu.

5. Hold down the jog key to enter the link 

mode.

6. A chime from the transmitter notifies the 

operator that the transmitter has entered 

the link mode.

   “Beep beep beep”
   (Enters the link mode for 20 seconds)

7. Immediately turn on the receiver power.
   The receiver will enter the linking state 

(LED blinks red) about 3 seconds after the 

receiver power is turned on.

8. If the receiver ID is displayed in the 

transmitter and the LED changed from red 

blinking to a steady green light, linking is 

complete. (The receiver linking wait state 

ends in about 3 seconds.)

9. Check system operation. If the transmitter 

and receiver are not linked, try linking 

again.

* If there are many T-FHSS Air systems turned on in close 

proximity, your receiver might have difficulty establishing 

a link to your transmitter.  This is a rare occurrence.  

However, should another T-FHSS Air transmitter/receiver 

be linking at the same time, your receiver could link to 

the wrong transmitter.  This is very dangerous if you do 

not notice this situation. In order to avoid the problem,we 

strongly recommend you to double check whether your 

receiver is really under control by your transmitter. 

*When  the  linked  transmitter  power  is  turned  on, 

communications begins.

*When using 2 receivers, perform the linking operation the 

same as the 1st receiver. (However, when 2 receivers are 

used, the telemetry system cannot be used.)

*Link is required when a new model is made from a model 

selection.