Futaba 10J F4109 Data Sheet
Product codes
F4109
76
Common function
R.P.M : Display of SBS-01RM/RO(Option), and alarm setup
ON
2 Position
3 Position
OFF
ON
OFF
OFF
R.P.M
(ALARM) (VIB) (LIMIT)
UP▶INH ▶OFF ▶ 0
DN▶INH ▶OFF ▶ 0
TYPE▶ OPT. FIN▶ 0
SPEECH▶ INH SW▶ NULL
0 rpm
0 rpm
MAX=
● Y o u c a n h e a r t h e
RPM data through an
earphone or headset,
by Activating the Speech
function.
● Switch selection
TYPE 1
TYPE 2
TYPE 3
"VIB" type
If the following types are selected, the
transmitter will vibrate during the warning.
RPM is a screen which displays / sets up the
RPM information from an optional RPM sensor.
The RPM of the model (engine, motor, etc.)
which is flying can be shown.
If it becomes higher or lower than the setting an
alarm and/or vibration will alert you.
●Select [RPM] in the TELEMETRY screen
and access the setup screen shown
below by press the Jog key.
● RPM
● T h e m a x i m u m w h e n
powering ON are shown.
●"MAG.(MAGNETIC)" or "OPT.
(OPTICAL)" is set according
to the sensor you use.
SBS-01RM : MAGNETIC
SBS-01RO : OPTICAL
●DN: Indicates that the
alarm will start when
the RPM falls below
the set value.
●UP: Indicates that the
alarm will start when
the RPM rises above
the set value.
Alert set : Over rotations
1. Move the cursor to the UP:ALERT item.
2. Select the ACT mode by press the +-key.
3. Move the cursor to the UP:(LIMIT) [value]item.
4. Ajust the rate by press the +-key.
Initial value: 2000rpm
Adjustment range: 0rpm~390,000rpm
(UP:(LIMIT) ≧ DN:(LIMIT))
*When the + - key simultaneous press, the rate is reset to the
initial value.
(To terminate the input and return to the
original state, touch the END key.)
Alert set : Under rotations
1. Move the cursor to the DN:ALERT item.
2. Select the ACT mode by press the +-key.
3. Move the cursor to the UP:(LIMIT) [value]item.
4. Ajust the rate by press the +-key.
Initial value: 0rpm
Adjustment range: 0rpm~390,000rpm
(UP:(LIMIT) ≧ DN:(LIMIT))
*When the + - key simultaneous press, the rate is reset to the
initial value.
(To terminate the input and return to the
original state, touch the END key.)
●In "MAGNETIC", the gear ratio
of your engine (motor) you are
using is entered.
●In "OPTICAL", the number of
blades("FIN") of the propeller ( r o
t o r ) your model is entered.
*A RPM sensor must be installed in the aircraft.
● Maximum
date reset by
pressing the Jog key for 1
second.