Futaba 10J F4109 Data Sheet

Product codes
F4109
Page of 174
78
Common function
VARIO
  (ALARM)     (VIB)       (LIMIT)
 UP▶INH     ▶OFF         ▶   +50
 DN▶INH     ▶OFF         ▶     -50
 
 SPEECH▶  INH        SW▶ NULL 
0 m/s
0 /                0
MIN/MAX=
VARIO is a screen which displays / sets up the 
variometer information from an optional altitude 
sensor or GPS sensor. 
The variometer of the model which is flying can 
be known.
If it becomes higher or lower than the setting  an 
alarm and/or vibration will alert you.
● Conversion of a display unit is performed by "TELEMETRY 
UNIT" of "PARAMETER".
●Select [VARIO] in the TELEMETRY screen and access the 
setup screen shown below by press the Jog key.
●"DN"  indicates  the 
alarm  will  start  when 
t h e   v a r i o   r e a c h e s 
below your set value.
●"UP"indicates the alarm 
will  start  when  the 
vario  reaches  above 
your set value.
Alert set : Rise side
1. Move the cursor to the UP:(ALERT) item. 
2. Select the ACT mode by press the +-key. 
3. Move the cursor to the UP:(LIMIT)[value]item. 
4. Ajust the rate by press the +-key.
  Initial value: +50(m/s)
  Adjustment range: -150~+150(m/s)
(UP:(LIMIT) ≧ DN:(LIMIT))
*When the + - key simultaneous press, the rate is reset to the 
initial value.
(To terminate the input and return to the 
original state, touch the END key.)
Alert set : Low side
1. Move the cursor to the DN:(ALERT) item. 
2. Select the ACT mode by press the +-key. 
3. Move the cursor to the UP:(LIMIT)[value]item. 
4. Ajust the rate by press the +-key.
  Initial value: -50(m/s)
  Adjustment range: -150~+150(m/s)
(UP:(LIMIT) ≧ DN:(LIMIT))
*When the + - key simultaneous press, the rate is reset to the 
initial value.
(To terminate the input and return to the 
original state, touch the END key.)
*An altitude sensor or GPS sensor must be installed in the aircraft.
●Variometer
VARIO : Display of SBS-01A / SBS-01G(Option), and alarm setup
ON
2 Position
3 Position
OFF
ON
OFF
OFF
● Switch selection  
TYPE 1
TYPE 2
TYPE 3
"VIB" type
If  the  following  types  are  selected,  the 
transmitter will vibrate during the warning.
● Y o u   c a n   h e a r   t h e 
Vario  data  through  an 
earphone  or  headset,  
by Activating the Speech 
function. 
●The  maximum  and  the  minimum 
when powering ON are shown.
● Maximum and minimum date reset by 
pressing the Jog key for 1 second.