Alinco DJ-X-7 E hand-held scanner 1839 Data Sheet
Product codes
1839
20
4
Basic
O
perations
It is not possible to program duplicated frequencies to
a skip-search channel. If you try to do so, an error
beep will sound.
a skip-search channel. If you try to do so, an error
beep will sound.
■Programming to memory channel
Here are the instructions for programming a frequency to a
memory channel. It is necessary to have the
memory channel. It is necessary to have the
icon appear
while you are following the step 2 to 4. If the icon disappears,
press the [F] key to continue.
press the [F] key to continue.
1. In the VFO mode, tune to the frequency you wish to
program by rotating the dial.
2. Press the [F] key.
The
icon appears on the LCD. The bank type is displayed
as well.
3. Press the
key to select a bank you wish to
program to.
Each bank corresponds to the following channel.
0-9 ...............Banks for normal memory channels.
0-9 ...............Banks for normal memory channels.
(Note that the number of this bank may vary
depending on the factory default or can be varied
by using the editing software.)
depending on the factory default or can be varied
by using the editing software.)
PS ................A bank for programmed scan channels.
PAS..............A bank for skip-search channels.
Pri ................A bank for priority channels.
Select an appropriate bank as you desire.
PAS..............A bank for skip-search channels.
Pri ................A bank for priority channels.
Select an appropriate bank as you desire.
4. Select a channel by rotating the dial.
According to the bank, the number of programmable channels
is different as follows;
0-9 ...............Note that the programmable numbers of each
is different as follows;
0-9 ...............Note that the programmable numbers of each
channel may vary depending on how you separate
each bank. Total 1000 channels can be divided
into each bank.
each bank. Total 1000 channels can be divided
into each bank.
PS ................0A - 49b (50 pairs)
PAS..............000 - 099 (100 channels)
Pri ................000 - 009 (10 channels)
Blinking of the channel number indicates that the channel is
free to program. When the channel number does not blink, then
this indicates the channel is already registered.
PAS..............000 - 099 (100 channels)
Pri ................000 - 009 (10 channels)
Blinking of the channel number indicates that the channel is
free to program. When the channel number does not blink, then
this indicates the channel is already registered.
5. Press the
key to conclude the setting.
Now, the frequency you specified is programmed to the
channel. To call up the frequency, refer to "Memory mode" on
P.19.
channel. To call up the frequency, refer to "Memory mode" on
P.19.
• It is not possible to increase the number of memory
channels.
• It is not possible to overwrite to registered memory
channels with the factory default setting. If you wish
to enable memory overwriting, refer to "(14)Write-
protect function setting" on P.34.
to enable memory overwriting, refer to "(14)Write-
protect function setting" on P.34.
Memo
MW
PRI
V/P/M
BANK
BAND
BAND
NOTE