Voltcraft CO-100 Room Air Meter CO-100 Data Sheet

If the measured CO

2

 concentration is below threshold value 1 (factory settings 800ppm),

the green LED is lit. When the CO

2

 concentration set as threshold value 1 is exceeded, the

green LED goes out and the yellow LED lights up.

• Briefly press the „MODE“ button repeatedly (from the normal operating mode) until

„ALARM 1“ flashes on the display.

• Briefly press the button „ENTER“; the medium display line shows the display for

threshold value 1.

• Set threshold value 1 with the arrows „“ and „“. Below 1000ppm, the step width is

50ppm, above 1000ppm it is 100ppm.

• Briefly press the „ENTER“ button to save the setting.

¼

Threshold value 1 always needs to be set lower than threshold value 2!

If the measured CO

2

 concentration is below threshold value 2 (factory settings 1200ppm),

the green LED is lit. When the CO

2

 concentration set as threshold value 2 is exceeded, the

yellow LED goes out and the red LED lights up. A signal sound can also be emitted (for
muting the sound signal, see chapter 9 a).

• Briefly press the „MODE“ button repeatedly (from the normal operating mode) until

„ALARM 2“ flashes on the display.

• Briefly press the button „ENTER“; the medium display line shows the display for

threshold value 2.

• Set threshold value 2 with the arrows „“ and „“. Below 1000ppm, the step width is

50ppm, above 1000ppm it is 100ppm.

• Briefly press the button „ENTER“ to save the setting.

¼

Threshold value 2 always needs to be set higher than threshold value 1!