Intel i3-2328M FF8062701275100 Data Sheet

96

Datasheet, Volume 1

1.

Unless otherwise noted, all specifications in this table are based on post-silicon estimates and simulations 

or empirical data.

2.

Each processor is programmed with a maximum valid voltage identification value (VID), which is set at 

manufacturing and cannot be altered. Individual maximum VID values are calibrated during manufacturing 

such that two processors at the same frequency may have different settings within the VID range. This 

differs from the VID employed by the processor during a power or thermal management event (Intel 

Adaptive Thermal Monitor, Enhanced Intel SpeedStep Technology, or Low Power States). 

3.

The voltage specification requirements are measured across VCC_SENSE and VSS_SENSE lands at the 

socket with a 100-MHz bandwidth oscilloscope, 1.5 pF maximum probe capacitance, and 1-M minimum 

impedance. The maximum length of ground wire on the probe should be less than 5 mm. Ensure external 

noise from the system is not coupled into the oscilloscope probe. 

4.

Processor core VR to be designed to electrically support this current.

5.

Processor core VR to be designed to thermally support this current indefinitely.

6.

This specification assumes that Intel Turbo Boost Technology is enabled.

7.

Long term reliability cannot be assured if tolerance, ripple, and core noise parameters are violated.

8.

Long term reliability cannot be assured in conditions above or below Max/Min functional limits.

9.

PSx refers to the voltage regulator power state as set by the SVID protocol. 

10. Idle power specification is measured under temperature condition of 35 

o

C.

Long term reliability cannot be assured in conditions above or below Max/Min functional limits.

SLOPE

LL

Processor Loadline

XE
SV-QC
SV-DC
LV
ULV

—

-1.9
-1.9
-1.9 
-2.9
-2.9

—

mΩ

V

CCIO

Voltage for the memory controller 

and shared cache defined at the 

motherboard V

CCIO_SENSE

 and 

V

SS_SENSE_VCCIO

—

1.05

—

V

TOL

CCIO

V

CCIO 

Tolerance defined across 

V

CCIO_SENSE

 and V

SS_SENSE_VCCIO

DC: ±2% including ripple

AC: ±3% 

%

I

CCMAX_VCCIO

Max Current for V

CCIO

 Rail 

—

—

8.5

A

I

CCTDC_VCCIO

Thermal Design Current (TDC) for 

V

CCIO

 Rail

—

—

8.5

A