Vortech Engineering Supercharger System 4NT020-010 User Manual

FACTORY OIL

PRESSURE SENDER

VORTECH 1/8"NPT

x -4 x 90

°

1/8"NPT FEMALE / 1/8"BSP MALE
7P125-125

INSTALL IN PLACE
OF THE OIL PRESSURE
SENDER

1/8"NPT STREET FITTING

Locate and remove the oil pressure sender
from the oil pan. (Located to the driver’s side
of the oil filter.)

In place of the oil pressure sender, install the
supplied 1/8"BSPT male to 1/8"NPT female
fitting.

Insert the supplied 1/8"NPT street fitting into the
1/8"NPT female section of the installed fitting.

Install the factory oil pressure sensor into the
end of the street fitting. This positions the
sensor so that it is pointing away from the
engine block. (See Figs. 4-a, 4-b.)

Install the 1/8"NPT x –4 x 90° fitting into the
open hole in the street fitting. Orient the fitting
so that it points upward.

Connect one end of the supplied steel braid-
ed oil feed hose to the –4 end that is pointing
upward and route it up to the open –4 fitting
on the supercharger. Tighten both ends of the
hose.

Using the supplied adel clamp and 8-32 hard-
ware, secure the oil feed hose to the mount-
ing plate. (See Fig. 4-c.)

ADEL CLAMP