Horizon Fuel Cell Technologies Automobile Parts 180-1010 User Manual
18
Installation
Manual
FASS FUEL SYSTEM
STEP 5:
Installing Electrical Harness:
Use the following photo to complete
this step.
1.
Connect the male end of the wire harness to the female electrical connector on
the FASS System.
the FASS System.
2.
Route the wire harness along the frame rail and into the engine compartment
and connect the wire extension (part #WE-1001) to the female end of the WH-
1002.cab.
and connect the wire extension (part #WE-1001) to the female end of the WH-
1002.cab.
3.
Rout the red wire of the wire extension through rubber grommet located in the
fire wall.
fire wall.
4.
Using the fuse tap & flag terminal connect the “Red” lead from the wire
extension to a terminal on the circuit breaker board that is “hot” when the key is
on. Note: Connect the fuse tap to the hot side of the fuse.
extension to a terminal on the circuit breaker board that is “hot” when the key is
on. Note: Connect the fuse tap to the hot side of the fuse.
5.
Using the ring terminals connect the green wire, of the WH-1002 wire harness,
to the negative post and the red wire to the positive post of the battery.
to the negative post and the red wire to the positive post of the battery.
6.
Secure the relay in an upright position.
7.
Properly secure the wire harness and fuel lines with wire ties.