ITT SSV User Manual

Lift and handle the product carefully,

using suitable lifting equipment. Observe all

the accident prevention regulations.

When you receive the pump, check the outside of

the package for evident signs of damage. If the prod-

uct bears visible signs of damage, notify our distribu-

tor within 8 days from the delivery date.

2. STORING THE PACKED PRODUCT

Ambient temperature 3º F to 104º F.
Short Term: (Less than 6 months) Goulds Pumps

normal packaging procedure is designed to protect

the pump during shipping. Upon receipt, store in a

covered and dry location.
Long Term: (More than 6 months) Rotate shaft

several times every 3 months. Refer to driver and

coupling manufacturers for their long term storage

procedures. Store in a covered dry location.

3. UNPACKING THE PRODUCT

Use suitable equipment. Observe all the

accident prevention regulations in force. Lift

and handle the product carefully, using suit-

able lifting equipment.

When you receive the pump, check the outside of

the package for evident signs of damage. If the prod-

uct bears visible signs of damage, notify our distribu-

tor within 8 days from the delivery date.

4. HANDLING THE PRODUCT

Lift and handle the product carefully, using

suitable lifting equipment. Observe the

accident prevention regulations in force.
The product must be securely harnessed

for lifting and handling. Some electric pumps have

eyebolts that can be used for this purpose.

The installation operations must be carried

out by qualified and experienced personnel.

Use suitable equipment and protections.

Observe the accident prevention regulations in force.
Always refer to the local and/or national regulations,

legislation and codes in force relating to the selec-

tion of the installation site and the water and power

connections.

1. SITE SELECTION

Make sure that no obstructions or obstacles hinder

the normal flow of the cooling air delivered by the

motor fan. Make sure there is adequate clearance

around the pump for the maintenance operations.

Whenever possible, raise the pump slightly from

the level of the floor. See the figures below and at

the top of the next column for possible installation

configurations.

2. ANCHORING

The pump must be anchored securely with bolts to

a concrete foundation or equivalent metal structure

(shelf or platform). If the pump is large-sized and

needs to be installed near rooms inhabited by people,

suitable vibration-damping supports should be pro-

vided to prevent the transmission of the vibrations

from the pump to the reinforced concrete structure.

The dimensions of the pump base and anchoring

holes are shown.

1SV 2SV 3SV 4SV 33SV 46SV 66SV 92SV

Inches (mm)

L1 3.94 (100) 5.12 (130) 6.69 (170) 7.48 (190)
L2 7.09 (180) 8.46 (215) 9.44 (240) 10.44 (265)
L3 5.91 (150) 7.48 (190) 8.66 (220) 9.44 (240)
L4

9.65 (245) 11.42 (290) 12.4 (315)

Ø A

0.50 (13)

0.60 (15)

3. ANGULAR ALIGNMENT

Angular alignment of the suction and discharge

flanges can best be accomplished using calipers at the

bolt locations. See figure below.

NOTICE: DO NOT DRAW PIPING INTO PLACE BY

FORCING THE PUMP SUCTION OR DIS-

CHARGE CONNECTIONS.

ø A x N