Vortech Engineering Nissan 350Z/Infinity G35Supercharger System 2003-2006 User Manual

P/N: 4NZ020-010

12JAN07 v4.0 Nissan 350Z(4NZv4.0)

SUPERCHARGER MOUNTING PLATE INSTALLATION..(2003-2005 Standard
Output Engines Only.) ( For 2005 and Later “Rev-Up” Engines, Skip to
Section 6.), cont’d

Install the idlers in the postiions shown in Fig.
5-a. (if not already assembled). Make sure
that the 50mm screw (longer) is installed
through the top idler.

Using the 12mm screw set aside in Step 1,
install the aluminum idler with the bearing
retaining snap ring pointed towards the rear
of the vehicle. The screw should pass through
the idler, a pilot spacer, the 1.1" spacer and
the supercharger mounting plate. Install the
supplied nut and washer on the end of the
screw and tighten the idler so that the gilmer
belt is snug. (See Fig. 5-c.)

Install the supplied accessory drive belt.
Tighten the belt tensioner until the belt is
tight. Tighten the center nut on the belt ten-
sioner idler. (See the Figs. 5-d, 5-e.)

Skip Section 6 and proceed with
Sectlon 7.

Fig. 5-e / Accessory Drive Belt Routing

CRANK

PULLEY

POWER

STEERING

PULLEY

SUPPLIED ACCESSORY
DRIVE BELT

SUPERCHARGER

JACKSHAFT PULLEY

SUPPLIED

SMOOTH

IDLER

FACTORY

IDLER

PULLEY

ALTERNATOR
PULLEY

SUPPLIED GROOVED
IDLERS

Fig. 5-d