Vortech Engineering Nissan 350Z/Infinity G35Supercharger System 2003-2006 User Manual
P/N: 4NZ020-010
©2007 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
12JAN07 v4.0 Nissan 350Z(4NZv4.0)
9
6.
SUPERCHARGER MOUNTING PLATE INSTALLATION (2005 and Later
“Rev-Up” Engines), cont’d.
“Rev-Up” Engines), cont’d.
K.
Route the oil feed hose outside the driver’s
side frame rail and then to the fitting installed
near the oil filter and tighten. Use the sup-
plied zip-ties to secure.
side frame rail and then to the fitting installed
near the oil filter and tighten. Use the sup-
plied zip-ties to secure.
L.
Tighten all of the mounting plate screws.
M.
Install the air filter onto the supercharger inlet
and tighten the clamp.
and tighten the clamp.
N.
Install the idlers in the positions shown. (See
Figs. 6-e, 6-f.
Figs. 6-e, 6-f.
O.
Using the 12mm screw set aside in Step 1,
install the aluminum idler with the bearing
retaining snap ring pointed towards the rear
of the vehicle. The screw should pass
through: the idler, a pilot spacer, the 1.1"
spacer and the supercharger mounting plate.
Install the supplied nut and washer on the
end of the screw and tighten the idler so that
the gilmer belt is snug. (See Fig. 5-c.)
install the aluminum idler with the bearing
retaining snap ring pointed towards the rear
of the vehicle. The screw should pass
through: the idler, a pilot spacer, the 1.1"
spacer and the supercharger mounting plate.
Install the supplied nut and washer on the
end of the screw and tighten the idler so that
the gilmer belt is snug. (See Fig. 5-c.)
P.
Install the supplied accessory drive belt as
shown in Fig. 6-e. Tighten the belt tensioner
until the belt is tight. Tighten the center nut on
the belt tensioner idler.
shown in Fig. 6-e. Tighten the belt tensioner
until the belt is tight. Tighten the center nut on
the belt tensioner idler.
Q.
Use the supplied sheet-metal screw to secure
the coolant hose support bracket removed in
Section 1. (See Fig. 6-g.)
the coolant hose support bracket removed in
Section 1. (See Fig. 6-g.)
Fig. 6-g
Fig. 6-f
Fig. 6-e / Accessory Drive Belt Routing (300hp Engines)
POWER
STEERING
PULLEY
CRANK
PULLEY
FACTORY IDLER
PULLEY (NOT USED)
PULLEY (NOT USED)
SUPPLIED ACCESSORY
DRIVE BELT
DRIVE BELT
SUPPLIED
GROOVED IDLER
SUPPLIED Ø2.5"
SMOOTH IDLER
SUPPLIED Ø2.5"
SMOOTH IDLER
FACTORY BELT
TENSIONER IDLER
SUPERCHARGER
JACKSHAFT
PULLEY
JACKSHAFT
PULLEY
ALTERNATOR
PULLEY