Lantronix Network Hardware 900-598 User Manual
7: Line and Tunnel Settings
PremierWave XC User Guide
49
Using XML
Include in your file: <statusgroup name=”line” instance=”1”>
Tunnel Settings
Tunneling allows serial devices to communicate over a network, without “being aware” of the
devices which establish the network connection between them. Tunneling parameters are
configured using the Tunnel menu and submenus. The Tunnel settings allow you to configure
how the Serial-Network tunneling operates. Tunneling is available on all serial Lines. The
connections on one serial Line are separate from those on another serial port.
devices which establish the network connection between them. Tunneling parameters are
configured using the Tunnel menu and submenus. The Tunnel settings allow you to configure
how the Serial-Network tunneling operates. Tunneling is available on all serial Lines. The
connections on one serial Line are separate from those on another serial port.
Note:
The following section describes the steps to view and configure Tunnel 1 settings;
these steps apply to other tunnel instances of the device.
Serial Settings
This page shows the settings for the tunnel selected at the top of the page and lets you change
the settings. The Line Settings and Protocol are displayed for informational purposes and must be
configured from the Line pages.
the settings. The Line Settings and Protocol are displayed for informational purposes and must be
configured from the Line pages.
Table 7-3 Tunnel Serial Settings
Tunnel Serial
Settings
Settings
Description
Line Settings
Protocol
DTR
Select the conditions in which the Data Terminal Ready (DTR) control signal on the
Serial Line are asserted. Choices are:
Serial Line are asserted. Choices are:
Unasserted
TruPort = the DTR is asserted whenever either a connect or an accept mode
tunnel connection is active with the Telnet Protocol RFC2217 saying that the
remote DSR is asserted.
tunnel connection is active with the Telnet Protocol RFC2217 saying that the
remote DSR is asserted.
Asserted while connected = the DTR is asserted whenever either a connect or
an accept mode tunnel connection is active.
an accept mode tunnel connection is active.
Continuously asserted