Hughes DW6000 User Manual
Chapter 2 • Installing the indoor equipment
1033295-0001 Revision 2
13
SBC installation method
First assemble and install the satellite antenna. This includes
attaching the coaxial cables to the DW6000 Satellite In and
Satellite Out connectors. Remember to label the receive and
transmit cables. Because the entire commissioning process will
be done over the satellite, the receive and transmit cables must be
connected from the satellite antenna to the DW6000.
attaching the coaxial cables to the DW6000 Satellite In and
Satellite Out connectors. Remember to label the receive and
transmit cables. Because the entire commissioning process will
be done over the satellite, the receive and transmit cables must be
connected from the satellite antenna to the DW6000.
Then follow the steps below and refer to the illustrations on
page 14 through page 16 to install the DW6000. .
page 14 through page 16 to install the DW6000. .
Note:
Before beginning the installation, confirm that your
laptop’s TCP/IP settings are configured to "Obtain an IP address
automatically." See Appendix D – on page 115
automatically." See Appendix D – on page 115
CAUTION
Do not connect the power supply to the DW6000, or connect
the power supply to a power source, before instructed to do
so.
the power supply to a power source, before instructed to do
so.
CAUTION
• Do not block any ventilation openings. Do not install near
any heat sources such as radiators, heat registers,
ovens, stoves, or other apparatus (including amplifiers)
that produce heat.
ovens, stoves, or other apparatus (including amplifiers)
that produce heat.
• Recommended ventilation space around the top and
sides of the DW6000 assembly should be approximately 6
inches. Ventilation is necessary to avoid overheating.
inches. Ventilation is necessary to avoid overheating.