Hughes DW6000 User Manual
Chapter 2 • Installing the indoor equipment
1033295-0001 Revision 2
17
Obtain IP address and test
Ethernet connection
1. Restart the PC so it obtains an IP address from the DW6000.
Or use the command
ipconfig /renew
from a DOS
command line prompt.
2. The embedded DHCP server assigns IP address =
192.168.0.2 to the PC. The default Gateway address is set to
192.168.0.1. Figure 12 shows a sample Windows TCP/IP
Properties screen. (These may vary among different Windows
operating systems.)
192.168.0.1. Figure 12 shows a sample Windows TCP/IP
Properties screen. (These may vary among different Windows
operating systems.)
Make sure the installer PC can communicate with the DW6000
over the Ethernet connection. Enter
over the Ethernet connection. Enter
Ping <192.168.0.1>
at a
DOS prompt. Figure 13 shows a successful attempt; Figure 14
shows an unsuccessful attempt. If the PC fails to ping the
DW6000, there are issues with either the PC’s NIC or TCP/IP
configuration.
shows an unsuccessful attempt. If the PC fails to ping the
DW6000, there are issues with either the PC’s NIC or TCP/IP
configuration.
Note:
In countries outside North America, the DW6000 may be
plugged, with a physical adapter, directly into a 220 V outlet.
Different countries may have different standards and requirements.
Different countries may have different standards and requirements.
Note:
Whenever the LEDs do not function properly as described
above, check to be sure you have the correct power supply, PN
1031105-0001.
1031105-0001.
Figure 12: