Datacard Group RL90 User Manual

Status Monitor

RP90 Plus E and RL90 User Guide

27

•

The current state of the printer, such as ready. The icon changes with different 
states. See the table below.

The Printer Setting tab shows:

•

Controls for viewing or changing print settings:

—  Resin K Print Level, which sets the K 

resin ink print density.

—  Level of UV Ink and Level of Special Ink 

2 which are not supported.

—  Resin K Print Mode which sets the K 

resin ink print quality. If Fine is selected, 
the print quality improves but the printing 
speed is slower.

—  Cooling Time which sets the time in 

seconds to wait until the retransfer film 
peels off from the card after retransfer. The default value is 0.

No Printer is found.

Yellow

The printer power is not switched on. or the host PC and 
printer are not connected properly by the USB cable.

Ready

Green

The printer is ready and able to start card printing.

Initializing

Yellow

The printer is initializing. After the printer is initialized, it 
goes into Ready state.

Offline Mode

Yellow

The printer is in Setting mode or it is being cleaned. 
When the process ends, it goes into Ready state.

Preheating

Yellow

The heat roller is heating. When it reaches the correct 
temperature, the printer goes into Ready state.

Card Loading
Card Transporting
MG Encoding
Retransfer
Contact IC Encoding
No-Contact IC 
Encoding
Unloading
Printing

Yellow

The printer is issuing cards. The operating status during 
card issuing is indicated. When the card is issued, the 
printer goes into Ready state.

Power Saving

Yellow

The printer is in power save mode. To end Power 
Saving, press the RESET button on the printer and then 
press the ENTER button to initialize the printer.

Error

Red

.