Bosch Appliances Washer/Dryer WAP24201UC User Manual

13

▯

Make sure the water supply faucet is easily accessible 

when the washer is in use. The faucet should be 

turned off if the washer is going to be unused for 

extended periods of time.

▯

Make sure rubber washers are in place at both ends of 

the water supply hose. Missing washers could cause 

leaks.

▯

The connection points are under full water pressure. 

Turn on the water tap and check for leaks.

▯

Periodically inspect the water supply hose and replace 

with a new hose if cuts, kinks or leaks are observed.

Water connection hoses

▯

red - Hot water-hose

▯

blue - Cold water-hose

Attach this end to water tap. Hand tighten only.

machine. Hand tighten only.

The AquaSecure hose prevents potential flooding in the 

event the hose develops an internal leak. If the hose 

leaks, the indicator turns red and water flow is blocked.

▯

Do not reuse an old drain hose. Only use the drain 

hose and parts included with your washer.

▯

Do not kink or modify the water drain hose.

Height of drain point
Height difference between the floor and drainage point: 

max. 39 in. (100 cm).

Attach the drain hose using the elbow included with your 

washer.
Fit the drain hose to the elbow provided leaving a 

maximum of 4 inches of drain hose projecting. Insert this 

section of the drain hose into the drain pipe. Secure the 

elbow and hose with a nylon tie strap or the equivalent to 

keep the hose from coming out of the drain pipe during 

use.

Secure the drain hose to the sink siphon using a Ø 0.9 - 

1.6 in. (20-44 mm) hose clip (available from a hardware 

store).

PD[ƒ

PD[ƒ

LQ

FDEOHWLH

GUDLQ
SLSH