Bosch Appliances Security Camera NBC-265-W User Manual

114 en | Advanced Mode

IP Camera 200 Series

AR18-10-B012 | v1.54 | 2011.08

Installation and Operation Manual

Bosch Security Systems

The settings on this page are used to set advanced settings the 

network. Some changes only take effect after a reboot. In this 

case Set changes to Set and Reboot.

1.

Make the desired changes.

2.

Click Set and Reboot.

The device is rebooted and the changed settings are activated. 

The camera supports the SNMP V2 (Simple Network 

Management Protocol) for managing and monitoring network 

components, and can send SNMP messages (traps) to IP 

addresses. It supports SNMP MIB II in the unified code.

If On is selected for the SNMP parameter and a SNMP host 

address is not entered, the device does not send the traps 

automatically and will only reply to SNMP requests. If one or 

two SNMP host addresses are entered, SNMP traps are sent 

automatically. Select Off to deactivate the SNMP function.

To send SNMP traps automatically, enter the IP addresses of 

one or two target devices here.

To choose which traps are sent:

1.

Click Select. A dialog box appears.

2.

Click the check boxes of the appropriate traps.

3.

Click Set to close the window and send all of the checked 

traps.

To configure Radius server authentication, connect the camera 

directly to a computer using a network cable. If a Radius server 

controls access rights over the network, select On to activate 

authentication to communicate with the device. 

1.

Enter the user name that the Radius server uses for the 

camera in the Identity field.

2.

Enter the Password that the Radius server expects from 

the camera.