Denon AVR-3808CI User Manual



k

Set remote control ID.
Match  the  ID  setting  of  the  remote  control  unit  and  the 
receiver.

 

 

 

• When changing the remote ID, also change the AMP, iPod, TU and 

NET/DTU modes of the main remote control unit at the same time 
(vpage 62).

• When changing the remote ID, also change the sub remote control 

unit at the same time (vpage 67).

l

Make setting for 2-way remote control unit.

 

When using a 2-way remote control unit (RC-7000CI and RC-7001RCI, 
sold separately), set this to “Used”.

A0

Adjust display brightness of the receiver.

 

 

 

Press the DIMMER button.

Bright

Dim

Dark

OFF

A1

Protect settings from inadvertent change.

 

• When “Setup  Lock”  is  set  to “ON”,  the  settings  listed  below  can 

no longer be changed. Also, “SETUP LOCKED!” is displayed if you 
attempt to operate related buttons.

⋅  GUI menu operations

⋅  RESTORER

⋅  Night Mode

⋅  Parameter

⋅  Room EQ

⋅  Channel Level

⋅  Audio Delay

• To cancel the setting, press the MENU button to re-display the “Setup 

Lock” screen, then change the setting to “OFF”.

A2

This  sets  the  function  for  maintenance  by  a  DENON 
serviceperson or installer. (For professional use only.)

Only use this function if so instructed by a DENON serviceperson or 
installer.

This function allows a DENON serviceperson or installer to check the 
AVR-3808CI’s status and make settings via the Internet.

h

Select  the  conditions  to  turn  on  the  trigger  out  1  with 
respect to the zone, input source, surround mode.
For details about the trigger out function, see page 21.

j

This sets the conditions to turn on the trigger out 2, in the 
same way as “Trigger Out 1” above.

 

• When the power of the zone turned on/off, the trigger out turns on.
• Associated with the power supply of zones set to “ON”.

• When the input source set to on is selected, the trigger out turns 

on.

• Associated with respect to the input source for zones set to “ON” at 

“Setting with Respect to the Zone”.

• When the surround mode set to on is selected, the trigger out turns 

on.

• Associated with respect to surround modes that are set to “ON”.
• This can be set if the “MAIN ZONE” setting at “Setting with Respect 

to the Zone” is set to “ON”.

• Associated when an input source for which “Setting with Respect to 

the Input Source” is set to “ON” is selected.