Bosch Appliances Home Security System DVA-16K User Manual

RAID Subsystem DVA-16K | Installation Manual

Subsystem Monitoring  | en 29 

Bosch Security System

F.01U.027.799 | V2 | 2008.08

A shielded Ethernet cable must be used to connect the RJ-45 Ethernet port to a hub on a net-

work after you assign a permanent IP to the RAID subsystem. This enables you to manage your 

subsystem via the web. Two (2) LEDs located on the Ethernet port indicate the Ethernet con-

nection status. See Figure 4.4 for the locations of the two (2) LED indicators. Refer to 

Table 4.5 for the LED definitions. 

LAN Indicators

The BBU has an LED on the right side of the rear panel. (See Figure 4.5) The function is the 

same as the fifth LED on the controller module. The LED is off when the BBU is functioning 

normally and is able to sustain the cache memory. The LED flashes to indicate the BBU is 

charging. If the LED is illuminating amber, please re-charge the BBU or contact your system 

vendor to verify the problem.

BBU Module LED

Each PSU comes with a single LED at the back (see Figure 4.6), located just above the power 

switch that turns on the subsystem. This LED indicates the operational status of the PSU mod-

ule. Please refer to the PSU LED definitions shown in Table 4.6.

PSU Module LED

Green

ON indicates currently connected to a LAN

Green

BLINKING indicates active transmission

LAN Port LEDs Definitions