Panasonic Attune II Installation Instruction
18
Setting the Center Module
3
Insert the AC adapter for the wireless repeater
into the power outlet.
into the power outlet.
4
Hold down the PROGRAM button on the back
of the wireless repeater for approximately 3
seconds.
of the wireless repeater for approximately 3
seconds.
w
p The wireless repeater searches for a Center Module
in repeater ID registration mode. At this time, the
operation STATUS LED on the repeater lights up in
green and the RSSI/ID LED blinks green.
operation STATUS LED on the repeater lights up in
green and the RSSI/ID LED blinks green.
When registration is completed successfully, the following
confirmation pop-up screen is displayed and repeater ID
registration mode ends automatically. The wireless repeater
restarts automatically.
confirmation pop-up screen is displayed and repeater ID
registration mode ends automatically. The wireless repeater
restarts automatically.
w
p You can register only one wireless repeater to each
lane.
Note
How to delete an ID
Cancel registration of wireless repeaters.
1
On the Settings screen, touch the [Wireless
Repeater] button (, and then [Lane A/B]
button)*.
Repeater] button (, and then [Lane A/B]
button)*.
* This appears only when the WX-CC412 is used.
2
Touch the [ID Deletion] button.
w
p The following confirmation pop-up screen is
displayed. To continue ID deletion, touch the [YES]
button. To stop ID deletion, touch the [NO] button.
button. To stop ID deletion, touch the [NO] button.
w
p Touch the [YES] button, and the registration of the
wireless repeater is canceled.
w
p If the wireless repeater has not yet been registered,
you will not be able to touch the [ID Deletion] button.
Note
WX-CC411_PGQP1742ZA_SI_.indb 18
2014/01/17 18:11:21