Klark Teknik DN9340E User Manual

 

18 of 65 

  

 

 

Click on the Dynamic button of the Channel A or B Navigation Strip, as required.  (If staying 
on the same Channel you may prefer to click on a Dynamic tab). 

 

 

 

 

 

The upper Dynamic Mode tab is used to set the characteristic of the Threshold Dependent Dynamic EQ 

(   T-DEQ), bypass state and graph display mode (when a DN9340) for the current channel.  The lower 

Dynamic Shaping tab provides a control panel for each of the two Dynamic EQ sections that can be 

applied to the frequency response.  The Dynamic EQ sections can also be adjusted at the display by 
using the target cursor. 

 

Select a Proportional, Constant or Symmetrical Q 

characteristic from the EQ Type  drop down 
menu. 

Use the Unit Display   drop down menu to set the 
Dynamic EQ display mode that DN9340 units 
should assume when taken out of slave 

operation; this only comes into effect if the slave 

is a DN9430.  The choice made here has no 
effect on your AddIn device display. 

 

Refer to the DN9340/DN9344 Operators Manual for application notes on Equalisation modes 

and Q. 

The black graph

shows overall

response.  The

red graph shows

the response of
the selected LO

or HI Dynamic

The Dynamic 
section’s freq, 
level and Q are 
adjusted by 
dragging the 
‘target’ or  
setting values 

Dynamic Mode 
tab 

For a shelf 
dynamic, choose 
an EQ slope 

Tick the check box to switch the

PEQ section out of the circuit