Bosch HBLP751UC Manual

English 14

1. Insert the probe into the meat as described above.
2. Connect the probe to the oven. If the probe is not 

connected to the oven prior to starting Probe mode, an 
error tone sounds.

3. Press the Auto Probe touchpad. Use the soft keys at 

the bottom of the display to select screens to enter the 
desired food temperature, the oven mode to use and 
the oven temperature. Use the numeric keypad to enter 
the desired values. Press Enter on the numeric keypad 
to confirm the settings and to start the probe mode.
Note: The minimum probe temperature that can be set 
is 100° F (38° C) and the maximum is 450° F (232° C). 
If the probe temperature entered is outside this range, 
an error is displayed.
The displayed probe temperature is updated in 
increments of 5° during the cooking process.

When the probe temperature reaches the set 
temperature, the cooking mode turns off and an alarm 
tone sounds every 10 seconds for 2 minutes.
This screen remains in the display until it is cleared by 
pressing the Oven Clear/Off touchpad or until the 
probe is removed. The display then goes back to Stand 
By mode.

Note:
•

Probe is not available when a Oven Timer has been 
set.

•

To change the probe temperature press the probe 
Auto softkey. The display enters probe temperature 
editing mode and displays the message “SET PROBE 
TEMP”.  Enter the new probe temperature and press 
Enter to accept the new value.

•

Do not store the probe in the oven.

•

Always use the handle of the probe for inserting and 
removing.

•

Always use a potholder to remove the probe since it 
becomes hot.

•

The probe is only available for the upper oven in 
double oven units.

The Eco Chef program uses residual heat to reduce energy 
consumption during cooking. Eco Chef uses the meat 
probe and is suggested for beef roasts, pork roasts, whole 
poultry and lamb roasts.

To use Eco Chef:

1. Insert the probe.
2. Press the Eco Chef touchpad.
3. Select the meat and doneness.
4. Enter the desired cooking termperature.
5. Press Start.

The door must not be opened during the residual heat 
stage of Eco Chef.

The oven will monitor the internal temperature of the meat. 
When the meat is ready, the unit sounds an alarm tone.

The Sabbath mode enables those of particular faiths to use 
their ovens on the Sabbath.

The bake temperature must be within the Sabbath mode 
temperature range of 100° to 450° F. Once the Sabbath 
mode has been started the cooking temperature can be 
changed (within the Sabbath mode allowable temperature 
range) by using the numeric keypad and pressing Enter to 
confirm the new temperature. There is no visual or audible 

response to input and there is a 30 second delay before 
the new temperature is activated.

If the oven light is on during setup, it remains on throughout 
the Sabbath mode operation. If the oven light is off during 
setup, it remains off throughout the Sabbath mode 
operation.

1. No kitchen timers or oven timers may be running when 

Sabbath mode is entered. The probe must not be 
inserted.
The Bake mode must be running (or in the process of 
being set up to run). Press the Oven Timer soft key for 
five seconds.
If a timer is running or the probe is inserted or the 
temperature set is outside the acceptable Sabbath 
mode range when Sabbath mode attempts to startan 
error tone will sound
If no timers are running, the Sabbath mode display is 
shown.