Whirlpool CEM2793BQ Installation Instruction

2.  Connect neutral wire (white or center wire)) (D) of power 

supply cord under center terminal block screw (A). Tighten 

screw.

3.  Connect remaining wires under outer terminal block screws 

(F). Tighten screws. Finally, reinstall terminal block cover to 

dryer rear panel. Secure cover with hold-down screw.

Connecting Neutral Wire
1.  Loosen or remove center terminal block screw (A).

IMPORTANT: A 4-wire connection is required for mobile 

homes and where local codes do not permit the use of 3-wire 

connections. 
Direct wire cable must have 5 ft. (1.52 m) of extra length so 

dryer can be moved if needed. 
Strip 5" (127 mm) of outer covering from end of cable, leaving 

bare ground wire at 5" (127 mm). Cut 1

1

⁄

2

" (38 mm) from 3 

remaining wires. Strip insulation back 1" (25 mm). Shape ends 

of wires into a hook shape.

Connecting Neutral Ground and Neutral Wires
1.  Remove center terminal block screw (A) and the neutral  

ground wire (B) by removing the green external ground 

conductor screw (C).