Whirlpool CEM2793BQ Installation Instruction

2.  Place hooked end of neutral wire (white or center wire) (D) 

of direct wire cable under center terminal block screw (A), 

hook facing right. Squeeze hooked end together and tighten 

screw.

3.  Connect remaining wires under outer terminal block screws 

(F). Squeeze hooked ends together and tighten screws. 

Finally, reinstall terminal block cover to dryer rear panel. 

Secure cover with hold-down screw.

Connecting Neutral Ground and Neutral Wires (cont.)
2.  Connect neutral ground wire (B) and place hooked end (hook 

facing right) of neutral wire (white or center wire) (D) of direct 

wire cable under center terminal block screw (A). Squeeze 

hooked ends together and tighten screw.

Connecting Direct Wire Ground
3.  Connect ground wire (green or bare wire) (E) of direct wire 

cable under green external ground conductor screw (C). 

Tighten screw.

Direct wire cable must have 5 ft. (1.52 m) of extra length so 

dryer can be moved if needed.
Strip 3

1

⁄

2

" (89 mm) of outer covering from end of cable. Strip 

insulation back 1" (25 mm). If using 3-wire cable with ground 

wire, cut bare wire even with outer covering. Shape ends of 

wires into a hook shape.

Connecting Neutral Wire
1.  Loosen or remove center terminal block screw (A).

Connecting Remaining Wires
4.  Connect remaining wires under outer terminal block screws 

(F). Squeeze hooked ends together and tighten screws. 

Finally, reinstall terminal block cover to dryer rear panel. 

Secure cover with hold-down screw.