Fagor 60CFG30B Installation Guide
9
2/ INSTALLING YOUR APPLIANCE
INSTALL THE HOOD
Note: at least two people will be required to mount the
hood.
1.
Raise the hood into its mounting position.
2.
Align the rectangular opening on the back of the hood with
the wall-mounting bracket. Gently lower the hood until it
securely engages the bracket.
the wall-mounting bracket. Gently lower the hood until it
securely engages the bracket.
3.
Open the Al. filter and find the two Ø8 mm holes on the
back of the hood. Level the hood with 2 mounting screws
(4*30mm) with washer. Use drywall anchors provided.
back of the hood. Level the hood with 2 mounting screws
(4*30mm) with washer. Use drywall anchors provided.
4.
Put the glass in the lead way, use four screws (4x25mm)
with glass washer and rubber washer to fix the glass.
(Note: the screws and washers should be installed as
shown.)
with glass washer and rubber washer to fix the glass.
(Note: the screws and washers should be installed as
shown.)
5.
Measure the height of the slide duct fixing support. Adjust
the height of the chimney according to the height. Then
use the duct fixing support with two screws (4x8mm) to
fix the chimneys. Shown as in the pic.
the height of the chimney according to the height. Then
use the duct fixing support with two screws (4x8mm) to
fix the chimneys. Shown as in the pic.
6.
Put the chimney on the hood, use two screws(4x8mm)to
fix the chimney to the duct fixing support.
fix the chimney to the duct fixing support.
7.
Use the other two screws (4x8mm) to fix the bottom of
chimney.
chimney.
8.
After adjusting the position, open the filter and fix the body
inside with safety screws
inside with safety screws
(4X30MM).
EN