Electrolux EI30DS55LW Installation Instruction

H1

H2

H3

H4

The counter-top around the cut-out should be flat and leveled (see 
hatched area on illustration 1).
Before installing the unit, measure the heights of the two (2) cabinet 
sides (H1-4), front and back (Illustration 1) from the floor to the top of 
the counter.

Illustration 1

Shave

Raised

Edge

to Clear

Space for

a 31½"

(81 cm) Wide 

Cooktop.

1 ½" Max.

(3.8 cm Max.)

Remove the protective channels on each side of the cooktop (if provided).

Slide the unit into the cabinet. Make sure the center of the unit is aligned with 
the center of the cabinet cut-out.

Illustration 2

To successfully 

install the 

range, the initial 

level height 

from floor to 

underside of 

cooktop frame 

should be at 

least 1/16" 

taller than 

cabinet sides 

as measured in 

step 2.

Level the range using the 

two (2) front leveling legs 

and the two (2) adjustable 

leveling wheel, so that 

the height from the floor 

to the underside of the 

metal flange is greater 

than the tallest cabinet 

After the installation, MAKE SURE that the unit is 
supported by the two front leveling legs and the two 
adjustable leveling wheels and NOT by the cooktop.

Metal 

Flange

The metal flange under each side of the cooktop MUST be placed 
over the cabinet countertop for proper unit support. The cooktop 
should NOT rest directly on the countertop (see illustration 2) or else 
it could cause damage to the cooktop voiding the warranty. Level 
the unit if needed.

measurement by at least 1/16" (see Ill. 2).

Remove and discard the two rear leveling legs, they are only in 
place to solidify the unit for the transport.