Sony PCS-1P User Manual

2-1

PCS-1/1P

A self-loop is the reflected loop in the codec of the main

unit.

1.

The launcher menu below is displayed when the power

switch of a communication terminal is turned on.

2.

Select a dial using the 

↑

, 

↓

, 

←

, and 

→

 buttons of a

remote controller and press the ENTER button or the
CONNECT/DISCONNECT ( / ) button of a remote

controller.
The dial menu is displayed.

3.

Select the line type.

Select “Line Type” using the 

↑

, 

↓

, 

←

, and 

→

 buttons

of a remote controller and press the ENTER button.

Then, select “LAN” or “ISDN” using 

↑

 and 

↓

 buttons

and press the ENTER button.

4.

Select the number of lines used.
Select “LAN Bandwidth” or “Number of Lines” using

the 

↑

, 

↓

, 

←

, and 

→

 buttons of a remote controller and

press the ENTER button.

Then, select “1920 kbps” or “12B” using the 

↑ 

and 

↓

buttons and press the ENTER button.

5.

Select column IP or A using the 

↑

, 

↓

, 

←

, and 

→

buttons of a remote controller and press the ENTER

button.
Enter 

* in column A from a remote controller two

times.

6.

Select “Dial” using the 

↑

, 

↓

, 

←

, and 

→

 buttons of a

remote controller and press the ENTER button or the

CONNECT/DISCONNECT ( / ) button of a remote
controller.

A self-loopback is started and “Dialing” is displayed
on the monitor screen.  “Meeting starts!” is displayed

when the loopback is completed.  In this case, confirm
that an image and voice are looped.