Multi-Tech Systems MVP2400 User Manual
MultiVOIP User Guide
Technical Configuration (Analog)
166
Analog Telephony Interface Parameters
(for MVP210/410/810)
(for MVP210/410/810)
The following parameters must be known about the PBX or telco
central office equipment to which the analog MultiVOIP will connect: :
central office equipment to which the analog MultiVOIP will connect: :
➼ Analog Phone Parameters
Ask phone company or
telecom manager.
telecom manager.
Needed for:
MVP810
MVP410
MVP210
MVP810
MVP410
MVP210
Analog Telephony Interface Parameters:
Record for this VOIP Site
@
•
Which interface type (or “signaling”) is used?
E&M
_____
FXS/FXO
_____
•
If FXS, determine whether the line will be used for a
phone, fax, or KTS (key telephone system)
•
If FXO, determine if line will be an analog PBX
extension or an analog line from a telco central office
•
If E&M, determine these aspects of the E&M trunk
line from the PBX:
•
What is its Type (1, 2, 3, 4, or 5)?
•
Is it 2-wire or 4-wire?
•
Is it Dial-Tone or Wink?
Write down the values for these telephony parameters. You will need
to enter these values in the “Interface” screen in the Configuration
section of the MultiVOIP software.
to enter these values in the “Interface” screen in the Configuration
section of the MultiVOIP software.