Multi-Tech Systems MVP2400 User Manual
Mechanical Installation & Cabling
MultiVOIP User Guide
68
Cabling
Cabling Procedure for MVP2410/3010
Cabling your MultiVOIP entails making the proper connections for
power, command port, phone system (T1/E1 line connected to PBX or
telco office), and Ethernet network. Figure 3-8 shows the back panel
connectors and the associated cable connections. The following
procedure details the steps necessary for cabling your MultiVOIP.
power, command port, phone system (T1/E1 line connected to PBX or
telco office), and Ethernet network. Figure 3-8 shows the back panel
connectors and the associated cable connections. The following
procedure details the steps necessary for cabling your MultiVOIP.
1. Connect the power cord to a live AC outlet, then connect it to the
MultiVOIP’s power receptacle shown at top right in Figure 3-8.
ETHERNET COMMAND
DIGITAL VOICE
ETHERNET COMMAND
10 BASET
RS232
DIGITAL VOICE
TRUNK
T1
PBX
PSTN
Telephony Connection
:
Network Connection
Command Port Connection
Hub
Figure 3-8. Cabling for MVP2410/3010
2. Connect the MultiVOIP to the PC (the computer that will hold the
MultiVOIP software) using the RJ-45 to DB9 (female) cable provided
with your unit. Plug the RJ-45 end of the cable into the Command
port of the MultiVOIP and connect the other end (the DB9 connector)
to the PC serial port you are using (typically COM1 or COM2). See
Figure 3-8.
with your unit. Plug the RJ-45 end of the cable into the Command
port of the MultiVOIP and connect the other end (the DB9 connector)
to the PC serial port you are using (typically COM1 or COM2). See
Figure 3-8.