Multi-Tech Systems MVP2400 User Manual

3. Connect a network cable to the Ethernet connector on the back of the

MultiVOIP.  Connect the other end of the cable to your network.

4. Turn on power to the MultiVOIP by setting the power switch on the

right side panel to the ON position.  Wait for the Boot LED on the
MultiVOIP to go off before proceeding.  This may take a couple of
minutes.

Proceed to Chapter 4 “Software Installation.”

Cabling involves connecting the MultiVOIP to your LAN and telephone
equipment.

1. Connect the power cord supplied with your MultiVOIP to a live AC

outlet and to the power connector on the back of the MultiVOIP as
shown at top right in Figure 3-10.

Ethernet Connection

Command Port Connection

E&M

FXO

PSTN

FXS

2. Connect the MultiVOIP to a PC by using a DB-25 (male) to DB-9

(female) cable. Plug the DB-25 end of the cable into the Command
port of the MultiVOIP and the other end into the PC serial port. See
Figure 3-10.