ZyXEL Communications n/a User Manual

Chapter 21 WAN Commands

DSL & IAD CLI Reference Guide

• Opens the ADSL line in ADSL2+ mode.

• Activates rate adaption.

• Displays the ADSL operation mode.

• Displays ADSL status.

Use these commands to configure the ZyXEL Device’s ATM (Asynchronous Transfer Mode) 
settings.

ras> wan adsl reset

...............................................................................

.

................ras>

ras> wan adsl version

ADSL Chipset Vendor: TI AR7 06.00.04.00

ras> wan adsl open adsl2+

ras> wan adsl rateadap on

ras> wan adsl opmode

DSL standard: NORMAL

ras> wan adsl status

current modem status: down

ras>

Table 62   wan atm Commands

wan atm vchunt active <yes|no>

Enables or disables the virtual circuit (VC) auto-
hunting feature.

wan atm vchunt add <node-id> <vpi> 

<vci> <service-bit-hex>

Configures a virtual circuit hunting pool entry. 

<node-id>

 : input the remote node index 1-8

<vpi>

: VPI value 

<vci>

: VCI value

<service-bit-hex>

: This is a six-bit field which 

controls the services the ZyXEL Device searches. 
The bits control the following services:

Bit 0 (1): PPPoE/VC

Bit 1 (2): PPPoE/LLC

Bit 2 (4): PPPoA/VC

Bit 3 (8): PPPoA/LLC

Bit 4 (16): Enet/VC

Bit 5 (32): Enet/LLC

You must enter the parameter value in hexadecimal 
format. For example, if you want to enable PPPoA/
VC (4 in decimal) and Enet/LLC (32 in decimal), 
enter “24” (4 + 32 = 36 in decimal = 24 in 
hexadecimal).

Note: Use the wan atm vchunt save 

command to add the entry to the 
hunt pool.