ZyXEL Communications n/a User Manual

 Chapter 21 WAN Commands

DSL & IAD CLI Reference Guide

wan backup dialbackup ATresponse 

callid <call-id>

Specifies the keyword preceding the dialed number.

wan backup dialbackup ATresponse 

clid <clid>

Sets the keyword preceding the Calling Line 
Identification in the AT response

wan backup dialbackup ATresponse 

speed <speed>

Specifies the keyword preceding the connection 
speed.

wan backup dialbackup callctl 

callbackdelay <seconds>

Sets the number of seconds the ZyXEL Device 
waits between dropping a callback request call and 
dialing the corresponding callback call.

wan backup dialbackup callctl 

dialtimeout <seconds>

Sets the number of seconds the ZyXEL Device tries 
to make a call before timing out.

wan backup dialbackup callctl 

droptimeout <seconds>

Sets the number of seconds the ZyXEL Device 
waits before dropping the DTR signal if it does not 
receive a positive disconnect confirmation.

wan backup dialbackup callctl 

retrycount <metric>

Sets the number of times the ZyXEL Device tries a 
busy or no-answer phone number before 
blacklisting it.

wan backup dialbackup callctl 

retryinterval <seconds>

Sets the number of seconds the ZyXEL Device 
waits before calling a busy or unanswered number 
again.

wan backup dialbackup dropDTR 

<0:no|1:yes>

Activates or deactivates the dropping of the Data 
Terminal Ready (DTR) signal after the wan backup 
dialbackup ATcommand drop <command>

 

string is issued.

wan backup dialbackup init <command>

Sets the AT command used to initialize the WAN 
device connected to the dial backup port.

wan backup dialbackup portspeed 

<1:9600|2:19200|3:38400|4:57600|5:1

15200|6:230400>

Sets the speed of the connection between the dial 
backup port and the external device.

wan backup display

Shows the WAN backup information currently 
stored in the memory buffer.

wan backup free

Clears the WAN backup information in the working 
buffer.

Note: Use this command before working 

on another WAN backup profile.

wan backup icmptimeout <seconds>

Sets the timeout in seconds for an ICMP ping.

wan backup load

Loads the WAN backup configuration into the 
working buffer.

wan backup recovery <seconds>

Sets the number of seconds the ZyXEL Device 
waits, when using a WAN backup connection, 
before trying to reconnect using the higher priority 
connection.

wan backup save

Saves the current setting in the WAN backup 
working buffer to the permanent memory.

Note: Changes to the configuration in the 

working buffer are not saved or 
used until you enter this command.

Table 63   wan backup Commands (continued)