Barco 26-0405000-00 User Manual

Working with Layers

With PresentationPRO-II, you can perform the following types of Key transitions:

„

Use the following steps to transition a Key to Program:  

1.  Ensure that you have preset the desired transition type and rate.  Refer to the 

"

" section on page 115 for details.

2.  In the Layer Functions Section, ensure that the KEY button is blinking.  If not, 

press 

KEY to display the Key Adjustment Menu.  Please note:

If there is no source on Program, the last source associated with the Key 
will blink on the 

Source Selection Bus. 

If there is a key source currently on Program, it will be lit solid on the 
Source Selection Bus. 

3.  On the Source Selection Bus, select a new key source.  The button blinks to 

indicate that the source is "pending."  

If there is no source on Program, only the pending source will blink.

If there is a source currently on Program, the pending source will blink 
and the current source will be lit solid.  

4.  In the Layer Functions Section, press TRANS.  The current Key transitions off, 

the new Key transitions on, and the 

TRANS button lights during the interval.  

5.  Adjust the Key’s clip, gain, mode, opacity, fill source, size and position, crop, 

source size and special effects desired.  Refer to the “

“ section on page 107 for details.  

From this point forward, transitioning a Key is a simple two-
button sequence:  (1) select key source, (2) press 

TRANS.

Ensure that you establish the Key’s initial clip, gain and 
opacity parameters before your live event begins.