Barco 26-0405000-00 User Manual

Serial Upgrade Method

g.  After the download is complete, navigate to the target folder and double-

click the 

EXE to launch the installation shield.  

h.  Follow the prompts to install the upgrade package in the desired folder.  

Note that at the conclusion of the procedure, a new path will be created 
under 

Start > Programs > Barco Folsom.  

4.  Connect the Serial 1 port on the back of the PresentationPRO-II to the COM 1 

port on your PC.  In Chapter 2, refer to the “

section on page 12 for the location of the 

Serial 1 port.

5.  Power-up the PresentationPRO-II.

6.  On the PC, click Start > Programs > Barco Folsom > PresentationPRO-II 

Software > PresentationPRO-II Flash Loader to launch the Flash Loader utility, 
as shown below.

Figure C-1.  Flash Loader Utility  

7.  Click Communication > RS232 Config > Baud, and select 115200.

8.  Click Communication > RS232 Config > COM Port, and select the COM port on 

your PC to which the PresentationPRO-II is connected.  If no other programs are 
using the port, the “

Established communications” message appears at the 

bottom of the Flash Loader.

9.  To verify communications between the PC and the PresentationPRO-II unit:

a.  In the loader program, click in the black terminal window area.

b.  Note the condition of the status lights:  

•

DCD and CTS should be red.

Do not move or copy any files out of the target folder.

If you have not used the 

COM 1 port on your PC, an error 

message will be shown at the bottom of the Flash Loader.