SVAT Electronics CLEARVU11 User Manual

now you can see

CLEARVU11

39

     NOTE:  If you look at the router there should be a green “link” light indicating that the DVR is properly 

connected to the port that it was plugged into. If this light is on, you can proceed to finding the DVR’s 

IP Address. 

Once the DVR is connected to the router you will need to find the IP address of the DVR. This is referred to as the 

“Internal IP Address” of the DVR.

 

6.  Make sure the “Net Type” is set to DHCP. This setting is acceptable for 

most users. If your router does not support DHCP or the DVR needs to 

store PPPoE (ADSL) settings contact your network administrator or 

ISP (Internet Service Provider) for the proper IP address settings. 

To check the DVR’s IP address:

1.  Press the Menu button.
2.  Select Login / Logout.
3.  Type in your username and press ENTER. Type in your password and press ENTER.
4.  Select Setup and press ENTER.
5.  Select Network and press ENTER. You are now at the network setup screen.

 NOTE: By default, the DVR network settings are set to DHCP. This means the DVR will automatically get an IP     

 address from the router when it is connected properly.

7.  Write down your IP address, Subnet Mask, Default Gateway, and 

DNS on the notes section. This information will be used to view the 

DVR on your computer and also assist in being able to view the DVR 
over the Internet.

8.  Press “ESC” to exit out of Menu. Press ENTER to save changes.

9.  Once you see confirmation, Press ENTER again. You have 

successfully configured your network settings.