SVAT Electronics CLEARVU11 User Manual

SVAT ELECTRONICS

now you can see

CLEARVU11

NETWORKING GUIDE

NOTE: This guide was created using a cable modem and some procedures will be slightly different depending on

your hardware. If you are using a DSL modem, you may need to enter your PPPoE settings into the
DVR (User name and password provided by your ISP). For more information refer to your modem’s
manual or contact your Internet Service Provider (ISP).

Before you start let’s make sure that you have everything you need to do this properly. You should have

these ready and connected before beginning:

DVR connected to a router.

Router connected to the Internet.

A PC or laptop that is connected to the same router that the DVR is connected to. The PC can be connected by a

wired or wireless connection.

Internet Explorer 5.0 or greater (To check the version of Internet Explorer: Open IE. In the top menu bar click on

“Help” and then click on “About Internet Explorer”. The version of IE will be displayed).

A genuine and fully updated version of Windows XP or Vista.

Important: The computer and DVR need to be connected to the same router. A computer will not always

be necessary at the location to view the DVR.

CONNECTING YOUR DVR TO THE ROUTER

1. Power off the DVR by using

the power switch on the back

of the DVR.

2. Connect the included network

cable to the back of the DVR in the

LAN port.

3. Connect the other end of the

network cable to an available port

on the router. The port on the

router should be labeled 1-4, or

1-8.

4. Once both ends are connected,

power on the DVR by using the

power switch on the back of

the DVR.