Epson DH200 User Manual

22

Using the Main Menu

Use the Display menu to configure 
the OSD and Auto Sequence 
settings.

To change display settings:

1. Select the DISPLAY SETUP tab, and 

configure the following:

• STATUS BAR: Select to Show or Hide the 

status bar on the OSD.

• CAMERA: Select to show the CAMERA NO. or 

the CAMERA TITLE or both.

• BORDER LINE: Set the color for the borders 

of the OSD: WHITE, BLACK, DARK GREY, or 
GREY

• BACKGROUND: Set the background color for 

disconnected cameras on the main display: 
GRAY, WHITE, BLUE, or DARK GREY

• SPLIT MODE: Set up to four split-screen 

display modes

• 

: Select 

 to enable/disable 

the quick setup menu

2. Press ENTER to save your changes and 

exit.

Sequential Setup

Configure Sequential Setup (Auto Sequence) 
settings.

To configure Sequential Setup settings:
1. Select the SEQUENTIAL SETUP tab and 

configure the following:

• DWELL TIME: Set from 1~30 seconds.

• SEQ. MODE: Set the display mode, from single 

channel full-screen to 8-channel 
split-screen

You 

must

 select one of these 

display modes to enable Auto Sequence 
mode. If none of these modes are 
selected, Auto Sequence 

will not

 begin.

• FULL SCREEN: Select channels for 

full-screen display. If selected, these 
channels will appear in full-screen during 
Auto Sequence mode

2. Press the ENTER button to save your 

settings and enable Auto Sequence. Auto 
Sequence will immediately begin.

3. Press the DISPLAY button to stop Auto 

Sequence.

Once you have configured the Auto Sequence 
settings in the Display menu, you can use the 
remote control to turn Auto Sequence on/off.

To enable/disable Auto Sequence:

1. Press and hold 

 on the front panel or 

remote control for 2 seconds.

2. To exit press 

. The main screen will 

return to a quad display.

Figure 12.0 Display menu

Figure 12.1 Auto Sequence setup