Epson DH200 User Manual

24

Using the Main Menu

• Press 

 enable/disable motion sensitivity. 

Disabled blocks are colored 

grey. Active 

blocks will be 

turquoise-colored when motion 

is detected. Move an object in front of the 
selected camera to test sensitivity and 
enable/disable the appropriate blocks

• Press 

 to exit the grid

• Press WX to select All/Clear 

and then press 

.

6. Press 

 to save your 

settings. Press 

 

to close remaining menu 
windows.

Configure recording parameters for 
each channel.

To configure recording settings:

1. Press 

ST

 to select a camera.

2. Press 

WX 

to select an option and the 

press 

 / 

 to configure the following:

• USE: Select ON/OFF. If OFF, the selected 

camera(s) will not record.

• QUALITY: Select LOW, MIDDLE, HIGH, 

SUPER, and ULTRA.

• RATE: Select 1, 2, 3, 4, 5, 6, 7, 10, or 15 fps.

• AUDIO: Select ON/OFF. Audio capable 

cameras or microphones are required for 
audio recording.

• MOTION: Select ON/OFF. Motion Grid and 

sensitivity must be configured in the Motion 
menu. See “MOTION” on page 23.

3. Press 

 to save your settings. Press 

 to close remaining menu 

windows.

Configure recording parameters for 
alarm recording.

NOTE: An external alarm device is not included 
with the system.

To configure alarm settings:

1. Under RECORD SETUP, press 

ST

 to 

select a camera. Press 

WX

 to select an 

option and press 

 / 

 to configure the 

following:

• USE: Select ON/OFF. If OFF, the selected 

camera(s) will not record.

• QUALITY: Select LOW, MIDDLE, HIGH, 

SUPER, and ULTRA.

• RATE: Select 1, 2, 3, 4, 5, 6, 7, 10, or 15 fps.

• AUDIO: Select ON/OFF. The number of audio 

input channels varies by model.

• INPUT: Select N.O/

N.C.

Select ALL.

Clear.

Figure 15.0 Record menu

Figure 16.0 Alarm menu

When you have 

configured settings for 

one camera, press 

 

to apply the settings for 

the rest of the cameras!