3com V7111 User Manual

 

Load your previously backed-up ini file, or the default ini file (received with the software 
kit). To load the ini file via the Embedded Web Server, refer to the V7111 User’s Manual. 

Press again on the ‘Reset’ button (this time for a short period). 

To restore the networking parameters of the V7111 24-PORT to their initial state, follow 
these 6 steps: 

Disconnect the V7111 24-PORT from the power and network cables. 

Reconnect the power cable; the gateway is powered up. After approximately 45 seconds 
the Ready LED turns to green and the Control LED blinks for about 3 seconds. 

While the Control LED is blinking, press shortly on the reset button (located on the left 
side of the front panel); the gateway resets a second time and is restored with factory 
default parameters (username: ‘Admin’, password: ‘Admin’). 

Reconnect the network cable. 

Assign the V7111 24-PORT IP address (see 

). 

Load your previously backed-up ini file, or the default ini file (received with the software 
kit). To load the ini file via the Embedded Web Server, refer to the V7111 User’s Manual. 

To access the Embedded Web Server, follow these 4 steps: 

Open a standard Web-browsing application such as Microsoft™ Internet Explorer™ 
(Version 6.0 and higher) or Netscape™ Navigator™ (Version 7.2 and higher). 

In the URL field, specify the IP address of the V7111 (e.g., http://10.1.10.10); the 
Embedded Web Server’s ‘Enter Network Password’ screen appears, shown in 

Figure 18.

 

Embedded Web Server Login Screen

 

In the ‘User Name’ and ‘Password’ fields, enter the username (default: “Admin”) and 
password (default: “Admin”). Note that the username and password are case-sensitive. 

3Com VCX V7111 Analog Gateway Installation Guide 

 31