Panasonic Section 520 User Manual

Section 520 - TSAPI

Chapter 3. Installation

DBS-92-520

Issued April 2000

  9

Caution: Installation of the DBS Driver must be performed by a Novell 
Netware Technician.

The Panasonic Telephony Services DBS driver ‘Panadrvr’ is a NetWare 
Loadable Module



 created to run on a Novell 3.12 or 4.X 486 (or greater) 

server with at least 8 megabytes of RAM and equipped with a serial port of 
9600 baud plus capacity (16550 UART required).

The driver is distributed on a single 1.44MB diskette. The diskette contains a 
root directory and two sub-directories as shown.

The root directory consists of a single ‘readme’ file which contains release 
information and last minute release changes. This ‘readme’ file also contains 
the differences between the trace and non-trace versions of the driver.

The release directory contains the non-trace enabled version of the driver and 
is the driver of choice for most, if not all, customers.

The trace directory contains the trace-enabled version of the driver and 
should be installed only when deemed necessary by Panasonic Technical Sup-
port. Note: This version is also valuable to application developers.

To install the Panasonic Telephony Services DBS driver, read the ‘readme’ 
file on the Panadrvr diskette and then copy the appropriate version of the 
driver from the diskette to the \SYSTEM directory of the 3.12 or 4.x Novell 
server. 

Panadrvr requires 3 runtime libraries on the server: clib.nlm, aiocomx.nlm, 
and tsrv.nlm. Panadrvr will attempt to self-load these nlms if they are not 
present at runtime. If these nlms are not present or cannot be loaded, the