Panasonic WJ-FS309 User Manual
38
●
Auto Reset
The alarm is automatically reset after the programmed
Alarm Output Time has elapsed.
The ALARM indicator changes from blinking to steady light.
Pressing the
Alarm Output Time has elapsed.
The ALARM indicator changes from blinking to steady light.
Pressing the
ALARM RESET
button will clear the alarm
and make the indicator go off.
●
External Reset
The alarm is reset by a recovery signal received from
the external equipment at pin 8 of the ALARM/REMOTE
connector.
The ALARM indicator changes from blinking to steady light.
the external equipment at pin 8 of the ALARM/REMOTE
connector.
The ALARM indicator changes from blinking to steady light.
2. Alarm Channel Monitor Mode
The picture of the channel where alarm is activated is dis-
played on the monitor if Alarm MLT OUT MODE is set to
SPOT. The picture displayed before alarm was activated
will be restored after the alarm is reset. It remains on the
monitor if Alarm MLT OUT MODE is set to OFF.
played on the monitor if Alarm MLT OUT MODE is set to
SPOT. The picture displayed before alarm was activated
will be restored after the alarm is reset. It remains on the
monitor if Alarm MLT OUT MODE is set to OFF.
■
Alarm Reset
●
Manual Reset
When an alarm is activated, the ALARM Indicator blinks.
The indicator keeps blinking until all alarms are cleared by
pressing the
The indicator keeps blinking until all alarms are cleared by
pressing the
ALARM RESET
button.
The blinking or lit indicator goes off.
ALARM
RESET